Jailbreak iOS 4.3.5 and iOS 5 Beta 6 with RedSn0w 0.9.8b7


Dev team has launched RedSn0w model 0.9.8b7 and contains two key parts. The primary part brings concerning the compatibility of the iOS 5 Beta 6 firmware with the iPad 1. As a result of it appears Apple has up to date the firmware recordsdata, with out adjusting the file title or model, so now the present model of the outdated and new firmwares RedSn0w iOS 5 Beta 6


Redsn0w Secondly, now is a new opportunity for the tethered support for 4.3.5 jailbreak and you are able to select in the iOS 4.3.5 firmware in RedSn0w  and no longer have to choose the older version 4.3.4. Furthermore, some errors regarding the jailbreak process should have been resolved. If you therefore you had problems with the jailbreak of iOS 4.3.5, you should test the new version RedSn0w. I adjusted my course for the new jailbreak guide RedSn0w version you can find below.

Here you can find the release notes from the Dev Team:

Apple updated the iPad1 iOS5b6 IPSW without changing its version number or file name, so we’re releasing redsn0w 0.9.8b7 to handle both the original and changed IPSW. We’ve also added explicit support for a tethered 4.3.5/4.2.10 jailbreak (instead of pointing at the IPSWs 4.3.4/4.2.9) and fixed a problem 4.2.10.

You cfollow instructions on the latest version of RedSn0w for  iOS version 4.3.5  jailbreak instructions below.

Furthermore, you have to remember that this still is a tethered jailbreak your device and connect it every time you restart the computer need to get it to start again with the help of RedSn0w. An untethered jailbreak will be released until the official release of IOS 5 by the Dev Team. Therefore, you must still wait a bit to you, if you wish not to use a tethered jailbreak.

Downloaded RedSn0w 0.9.8b7 for Windows  or Mac

Step 1:
Starts RedSn0w and selects the iOS 4.3.5firmware  for your device.

Step 2:
After your firmware has detected RedSn0w version, you must click on Next and the next window appears. There you need a hook on “Install Cydia” set, disable all others. Continue by clicking Next.


Step 3:
Next, you need your device off and connect to your computer. Then follow the instructions and click Next.



Step 4:
Now you have to bring your device into DFU mode. It pushes the “Power” button on your device for 3 seconds. Then you have to be the “Home” and “Power” button press for 10 seconds. Then it allows the “Power” button off and wait until the installation begins in RedSn0w.



Step 5:
The installation is now done. When the installation is complete your IOS device will reboot automatically. After that, the jailbreak is finished.



Important note:
This is it this is a tethered jailbreak, does your device every time you reboot or power loss in a boot loop logo. You can not use your device as long as until you have performed a tethered boat. For this you must perform the above steps again, but disable the check “Install Cydia” and instead use a hook with “Just boot tethered right now”. In this way your device is reusable.Unfortunately, you have to perform this operation on every reboot!

Follow us on Twitter, subscribe to our Facebook Page, find us on LinkedIn